Expert Electrician Services in Overland Park, Kansas

A lot of 1960s and 70s-era homes in Overland Park were wired with aluminum branch wiring during the copper shortages of that era. Aluminum expands and contracts more than copper, which loosens connections over time and creates heat at outlets and switches. It's a known fire risk and a red flag on inspections. We don't always have to rip it all out: properly installed approved connectors and pigtailing methods can make those connections safe, and we can tell you which circuits actually need full replacement.

Overland Park gets its share of severe weather, and the mature trees in older neighborhoods are a big part of the outage story. Wind takes down limbs onto service drops, lightning strikes surge through wiring, and hail chews up rooftop equipment. We inspect the meter, mast, and panel after storms, repair what's damaged on your side of the service, and install whole-home surge protection so one bad storm doesn't cascade into fried appliances and dead electronics.

North Overland Park's 1950s ranches and split-levels were built around 60- and 100-amp services, which made sense before central air, dishwashers, microwaves, and everything else. Today those panels run at the edge, and the symptoms are unmistakable: breakers that trip on hot afternoons, lights that dim when the compressor starts, and breakers that feel warm. We upgrade panels to properly sized equipment and add circuits where the load actually lives.

The city has seen waves of finished basements, kitchen remodels, and room additions over the decades, and the quality of the electrical work varies wildly. We regularly find splices buried behind drywall without junction boxes, bathroom circuits without GFCI protection, and additions tapped off already-loaded circuits. We audit the existing work, fix the hazards, and bring everything into compliance so your home is safe and passes inspection at resale.

In the older parts of town, especially near downtown and the original subdivisions, two-prong outlets and ungrounded circuits are still common. There's no safe ground path, which is a shock risk and means surge protectors can't do their job. We replace these with properly grounded receptacles, add GFCI and AFCI protection where code calls for it, and verify the grounding is real all the way back to the panel.

Winter ice and summer thunderstorms both hit overhead lines hard, and outages in Johnson County can stretch from hours to days after a big event. More homeowners are asking about standby power, but there's a lot to get right: proper transfer switches, correct sizing, safe fuel sources, and code-compliant installation. We help you plan a backup setup that keeps the essentials running safely without backfeeding the grid.

Many older Overland Park homes still have the original overhead service drop running from the pole to the house, and decades of Kansas wind have worn them down. Frayed insulation on the drop, a loose weatherhead, or a meter base with corroded lugs can cause flickering power, voltage drops, or a dead leg that kills half the circuits in the house. This is the homeowner's equipment, not the utility's, so Evergy can't fix it. We replace weathered drops, rebuild the mast and meter base, and make sure the whole service entrance is tight, grounded, and ready for another few decades of weather.