Expert Electrician Services in Narragansett, Rhode Island

Ocean air eats electrical equipment for breakfast. We find corroded meter sockets, rusted panel enclosures, and outdoor disconnects with green terminals in houses within sight of the water. The fix is marine-aware hardware: stainless and corrosion-resistant fittings, sealed enclosures, and regular attention to anything mounted outside. It costs a little more up front and lasts far longer.

Nor'easters and hurricanes push water into ground-floor panels, garage outlets, and crawlspace junction boxes along the coast. After a big storm we inspect everything the water touched, replace what the salt ruined, and talk about elevating equipment above the flood line where the house allows it. Prevention beats replacement every time.

Three-quarters of Narragansett's homes are single-family, and a lot of the older ones near the Pier and Point Judith still run on 100-amp service with a full panel. Central air, a hot tub, and an EV charger do not fit. We upgrade to 200 amps, and when the house sits in a flood-prone spot we plan the panel location with the water in mind.

Academic-year leases and summer turnover put unusual wear on rental wiring: loose receptacles, overloaded power strips, and smoke alarms with dead batteries. Landlords call us for safety inspections that catch the small problems before they become emergencies, and for quick, durable repairs between tenants.

Outdoor kitchens, pool equipment, landscape lighting, and dock power all live in the harshest environment on the property. We wire them with wet-location materials, proper GFCI protection, and disconnects you can actually reach. When the salt starts winning, we replace components before they fail instead of after.

The town's wooded inland streets lose power the way all of South County does: branches on lines, sometimes for hours. A standby unit with an automatic transfer switch, keeps the heat, the sump pump, and the refrigerator running without you lifting a finger. The unit gets sized to the house and, wire it to code.

Low-voltage landscape lighting and dock-area fixtures live the hardest life of anything on a coastal property, and we replace failed systems constantly. The usual culprits are corroded connections at every splice, transformers mounted where spray soaks them, and cable nicked by edging tools. We rebuild these systems with sealed connectors, properly rated transformers mounted out of the splash zone, and cable buried to the right depth, so the lights actually stay on through the season.

Coastal rentals and second homes often have a hot tub or an above-ground pool wired by the previous owner, and the safety steps get skipped: no proper bonding, undersized GFCI protection, or the disconnect mounted where you cannot reach it in an emergency. Water and electricity demand perfection. We rewire to code with correct bonding, GFCI protection, and an accessible disconnect, then test everything in front of you.

The ground rod and its clamp live outside in the worst of the salt air, and after twenty years many are green, loose, or half-buried in mulch. A compromised ground means surge protection cannot do its job and fault currents have nowhere safe to go. We replace corroded electrodes and clamps, verify continuity back to the panel, and make sure the whole grounding system is sound.